Care And Maintenance; Changing The Lightbulb; Cleaning The Appliance - Electrolux S85528KG1 User Manual

10 care and maintenance frost free refrigeration

Care and maintenance

warning
Before changing any light bulb, switch the power off
at the power point and remove the power cord from
the power point.
Changing the light bulb
• Refrigerator light
1. Switch off the power at the power
point and remove the refrigerator's
power cord from the power point.
2. Remove shelves.
3. Carefully unclip the light cover. You
do this by pulling the upper part of
the cover towards the front of the cabinet.
4. Unscrew the light bulb and replace it with a bulb that is
the same as the original. If, when you remove the light
bulb the small rubber "O" ring comes out with the bulb,
fi t the "O" ring over the new bulb and screw bulb into
the socket (see diagram).
Never insert your fi nger into the light bulb
socket to check for the presence of the "O" ring.
5. Replace the light cover by hooking the light cover lugs
into the bottom of the housing and pressing the upper
part of the cover until it clips in.
6. Replace shelves.
7. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
• Freezer light
1. Switch off the power at the power point and remove the
refrigerator's power cord from the power point.
2. Carefully unclip the light cover. You do this
by pulling the light cover tab at the rear
towards the front of the cabinet.
3. Unscrew the light bulb and replace it with
a bulb that is the same as the original. If,
when you remove the light bulb the small
rubber "O" ring comes out with the bulb, fi t the "O" ring
over the new bulb and screw bulb into the socket (see
diagram).
Never insert your fi nger into the light bulb
socket to check for the presence of the "O" ring.
4. Replace the light cover by hooking the light cover lugs
into the front of the housing and pressing the rear of the
cover up until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
tips and information
Ensure the 'O' ring is in place before replacing the bulb.
Light bulb "O" ring Light socket

Cleaning the appliance

warning
BEFORE CLEANING: Turn appliance off at the power
point, then remove power cord from socket. This will
make sure there is no chance of getting an
electric shock.
• Doors and exterior
– stainless steel
Your stainless steel appliance is manufactured from a
mark resistant stainless steel. This stainless steel has
a special advanced protective coating that eases the
removal of marks such as fi nger prints and water spots.
To keep your stainless steel appliance looking at its best,
you should clean it regularly. You should only clean the
stainless steel doors with luke-warm soapy water and
a soft cloth, rinsing with clean water and then wipe the
surface with clean water and a soft clean cloth to remove
soap residue.
– pacifi c silver
You should only clean the pacifi c silver doors with luke-
warm soapy water and a soft cloth, rinsing with clean
water and then wipe the surface with clean water and a
soft clean cloth to remove soap residue.
caution
Do not use stainless steel cleaners, abrasive pads
or other cleaners as they are likely to scratch the
surface. Damage to this product after delivery is not
covered by your warranty.
• Interior
You should clean the appliance interior regularly. It will
be easiest to clean when the food supply is low. Wash
the interior with a soft cloth and use an unscented mild
soap with lukewarm water. Thoroughly dry all surfaces
and removable parts. Avoid getting water on appliance
controls. If you have taken out any removable parts,
replace them and switch the power on before re-
stocking the appliance with food. Naturally, you should
keep the interior of your appliance hygienic by promptly
and thoroughly wiping up any food spills.
Don't use a steam cleaner. If live components come into
contact with condensing steam, they may short-circuit or
cause an electric shock.
• Door seals
Take care to keep door seals clean. Sticky food and
drink can cause seals to stick to the cabinet and
tear when you open the door. Wash seal with a mild
detergent and warm water. Rinse thoroughly and dry.
caution
Never use hot water, solvents, commercial kitchen
cleaners, aerosol cleaners, metal polishes, caustic or
abrasive cleaners, or scourers to clean this appliance,
as they will damage it. Many commercially available
cleaning products and detergents contain solvents
that will damage your refrigerator. When cleaning,
use only a soft cloth with an unscented mild soap and
lukewarm water.