Modula Bottle Caddy; Bottle Twist Holder; Twist Ice & Serve - Electrolux S85528KG1 User Manual

Modula bottle caddy

The Modula bottle caddy is made of anodised aluminium.
They are used to store various types of bottles like wine or
beer. Bottles should be stored with the bottom end towards
the back of the refrigerator. The fridge arrives with three
combined caddies, but they can be separated if desired.
Bottle twist holder operation (where fi tted)
The bottle twist holder is used to prevent bottles from falling
over. The bottle twist holder consists of two parts, a sliding
front, and a rotating retainer ring.
The bottle twist holder can be used in two positions:
• Horizontal
When the bottle twist holder ring is horizontal, any item
that fi ts within the ring can simply be placed inside it.
• Vertical
When the bottle twist holder ring is vertical, it is possible
to simply slide the bottle twist holder along the bottle
retainer bar until it is pushed up against a bottle.
Note:
The bottle should be constrained on the other side by either
the end of the bin or other adjacent bottles.
Twist Ice & Serve
To use, remove the tray, fi ll with
water and place back in the
freezer. Once ice has formed
(approximately 3 hours) simply
twist the knob at the front
clockwise until the ice drops
into the bin below.
frost free refrigeration using your appliance 9
Your Twist & serve ice can be relocated to the other
side of the freezer as follows:
1. Remove the ice bin and ice cube tray. If the ice tray
assembly is frozen to the carriage, simply squeeze the
tray and shelf together to break the ice.
2. Before you remove the ice carriage, remember to
disengage it from the glass shelf (as shown), as it may
result in damage to the assembly.
3. Remove the centre runner by disengaging it at the front
of the shelf, and removing it from the rear.
4. Refi t the runner in to the rear of the shelf on the right
hand side and then engage the front (as shown)
5. Fit the carriage by sliding it into the runners until the
front of the carriage engages
with the shelf.
6. Refi t the ice tray and ice bin.
Slide away glass shelf
This shelf can be used either as a full
depth shelf or when tall items need to be stored at the front
of the appliance it can be collapsed to half its original depth.
• To collapse the shelf:
1. Pull the front half of the shelf forward.
Insert into the slot at
the rear of the shelf
2. Then, from the underside, lift the front half of the shelf
by raising the rear edge over the recessed hook detail.
3. Pull the shelf forward and allow the rear to drop into the
side channels.
4. Push the front shelf backwards (3,4) until it reaches the
rear stops.
• Repositioning:
The shelf can be repositioned
within the appliance unit by
pulling the whole assembly
out until the side panels are
free to pivot down, then
pivoting the rear of the shelf
until the shelf is free from the
liner runners. The shelf can
then be positioned in any of
the runners – this is a very
useful feature if your appliance
door happens to have limited
access.
Then engage
into the front
of the shelf
Hook detail