Garmin G1000 Pilot's Manual page 146

GPS NAVIGATION
Selecting and activating a direct-to destination by entering an identifier:
1) Press the Direct-to (
2) Enter the destination waypoint identifier (Figure 5-19).
3) Press the ENT Key to confirm the identifier. The 'Activate?' field is highlighted (Figure 5-20).
4) Press the ENT Key to activate.
In addition to selecting a destination by an identifier, the Direct-to Window also allows the selection of
airports, VORs and NDBs by facility or city name (Figure 5-21).
Selecting a direct-to destination by facility or the name of a city:
1) Press the Direct-to Key. The Direct-to Window is displayed with the waypoint identifier field highlighted.
2) Highlight the facility or city name field.
3) Enter the facility or city location of the desired waypoint. If duplicate entries exist for the entered facility or city
name, additional entries can be viewed by turning the small FMS Knob during the selection process.
5-28
) Key.
Figure 5-19 Entering an Identifier
Figure 5-20 Activate Field
Figure 5-21 Entering a Facility Name
Garmin G1000 Pilot's Guide for the Beechcraft A36/G36
Activate Field
190-00595-00 Rev. A