Electrical Connection; Reversing The Door - AEG SANTO Series Operating Instructions Manual

Electrical Connection

A properly installed socket outlet with earthing contact is required for
electrical connection. Electrical fuse protection must be of at least 10
ampere.
If the outlet socket is no longer accessible after installation of the
appliance, appropriate measures must be taken during electrical instal-
lation to assure that the appliance can be disconnected from the mains
(e.g. fuse, circuit breaker, non-operate current safety-switch or the like,
with a contact opening of at least 3 mm).
0
1. Before initial start-up, refer to the appliance rating plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.: AC 220 ... 240 V 50 Hz or
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance at the left.
Warning: To avoid potential danger, if the mains connection lead of
this appliance is damaged, it must be replaced by our customer service
representative or a person with similar qualifications.
Warning: Under no circumstances should the appliance be connected
to electronic "power saving plugs" or to a.c.-d.c. converters which con-
vert direct current to 230 V alternating current (e.g., solar installations,
ship networks)

Reversing The Door

The door hinges can be changed if required to suit the location where
the appliance is installed.
Important! Only a qualified technician should change the side on
which the door is fixed. If this is necessary, please contact our Customer
Services or your dealer.
1
Warning! Unplug from the mains, before reversing the door.
818 37 09-01/6
220 ... 240 V~50 Hz
13