Advertisement
6. Block the installed screen using blocking bolts in the handles.
Fig.9
7. Delivered screen has end positions requested by the client. If the surface of the screen hangs too high or
too low, its position may be adjusted using key from the set (fig.10).
NOTE! End positions corrections may be done only by a qualified person. All corrections done are
one's own responsibility. In the case of incompetent corrections, the screen may sustain damage, which
is not covered by the warranty.
B A
Fig.10
8. In screens with side tensioning, unroll the surface completely. If necessary, adjust tension power with
bolts placed on both sides of the bottom bar using allen key.
w
w
w .
k
a
Limiting switch access
Limiting switch A: responsible for upside
position of the screen bar. Clockwise
regulation will stop the screen bar higher.
Anti-clockwise regulation will stop the
screen bar lower.
Limiting switch B: responsible for downside
position of the screen bar. Clockwise
regulation will stop the screen bar higher.
Anti-clockwise regulation will stop the
screen bar lower.
u
b
e
r .
e
-7-
u
Advertisement
