Vogt Hammer VH 10 Manual page 18

VOGT precision line lubricator Z300
Usable content
Max. operating pressure
Max. operating temperature
Operating pressure for processing various materials with the
VOGT Hammer / VOGT Hammer Delta VH 10, VH 25, VH 30, VH 50, VH 50.18, VH 60, VH 60.18
The operating pressure must be adjusted to the material and subsurface.
Recommendations:
cleaning joints
floor coverings, coatings
parquet, laminate
thin plaster, textured plaster
lime-gypsum plaster
lime-cement plaster
tiles, glued
tiles in a mortar bed
digging
compress
chiselling
Maximum operating pressure
Operating pressure for processing various materials with the
VOGT TurboSpade VTS 50, VTS 60
The operating pressure must be adjusted to the material and subsurface.
Recommendations:
Digging
Sealing
Mortising
Maximum operating pressure
Basic rule:
The lower the material resistance, the lower the operating pressure. The operating
pressure is too high if the tool "jumps away" from the material. Excessive pressure
NOTE
increases the vibration, reduces performance and can cause damage to the equipment.
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de
20 ml
16 bar (232 psi)
-10°C to +50°C
3,0 bis 5,0 bar (44 - 72 psi)
4,0 bis 6,0 bar (58 - 87 psi)
5,0 bis 6,0 bar (72 - 87 psi)
5,0 bar (72 psi)
5,0 bis 6,0 bar (72 - 87 psi)
6,0 bar (87 psi)
5,0 bis 6,0 bar (72 - 87 psi)
6,0 bar (87 psi)
6,0 bar (87 psi)
5,0 bis 6,0 bar (72 - 87 psi)
6,0 bar (87 psi)
6,0 bar (87 psi)
6,0 bar (87 psi)
5,0 to 6,0 bar (72 - 87 psi)
6,0 bar (87 psi)
6,0 bar (87 psi)
Subject to change without notice
37
EN