Vogt Hammer VH 10 Manual page 11

EN
CAUTION
WARNING
Check every 4 operating hours at the latest it there is a film of oil on the tool holder. If this is not the
case, add some drops of VOGT Special Oil to the connection hose. We fundamentally recommend that
a VOGT precision line lubricator be used during operation. If a VOGT precision line lubricator is already
being used, check its oil level and setting (see page 26). It is useful to grease the hexagon chisel holder
for high contact forces.
An excessive quantity of oil dampens the impact performance. Drops will form on the releasing lever
or tool holder. Reduce the quantity of oil at the lubricator (see page 26) in such instances and clean the
equipment if necessary (see page 31). The equipment or tool may become damaged if the quantity of oil
is too low. Check the oil supply, refill the oil if necessary or adjust the lubricator (see page 26).
CAUTION
If the equipment, tools or accessories are damaged, they should be repaired or replaced by a specialist
workshop or the manufacturer. As the manufacturer, we are able to supply necessary spare parts in the
quickest possible time and carry out repairs in the shortest time. If order numbers are required, they can
be found in the tool list in Section 12, or the spare parts list in Section 14.
Subject to change without notice
30
Limited levering is possible. Excessive levering can lead to the shaft
or tool breaking.
Risk of injury
Risk of falling if the shaft or tool is broken through an unexpected shift in weight.
Do not lever too heavily.
Risk of severe or fatal injury or equipment/tool damage if the release lever is permanently
locked in place.
Never lock the release lever in place using cable ties, tape or other means.
Vibration risks.
Permanent physical damage, such as feelings of numbness or damage to the nervous
system may develop if the human body is exposed to vibrations for an extended period.
The permissible operating times must be observed. Wear approved and tested
anti-vibration protective gloves if necessary.
If you release the releasing lever, the compressed air
supply is interrupted. The equipment stops after a
brief overrun period (depending on the length of the
equipment).
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de