MOTO GUZZI V85 E4 Manual page 27

Engine V85 E4
•
Remove the oil seal
CAUTION
IN CASE OF OIL SEAL REPLACEMENT, USE THE SUITA-
BLE PUNCH UNTIL IT REACHES THE CRANKCASE
Specific tooling
021020Y Clutch housing oil seal mounting
punch
Controllo alberi
Check transmission gears for signs of pitting and wear and replace damaged gears if necessary.
Check the gear fitting teeth for cracks, damage and wear and replace those damaged if necessary.
Check the transmission gears movement and, if it is not regular, replace the damaged part.
Specification
Maximum wear limit for the selection gear grooves
Minimum wear limit of the cardan shaft side secondary shaft
Minimum wear limit of the clutch side primary and secondary
shaft seats
Checking the clutch shaft
Check for pitting, wear, cracks or damage, signs
of deterioration on the teeth of the primary drive
gear and replace the gear if necessary
Specification
(1) Minimum wear limit of the rotation point on the gearbox
cover bearing
(2) Minimum wear limit of the rotation point on the gearbox
cover base
Checking the desmodromic drum
Check the desmodromic drum for damage, scratches and wear and replace the assembly if required.
WEAR LIMITS
seats
WEAR LIMITS
Desc./Quantity
22.78 mm (0.896 in) with rollers diam. 3.5 mm (0.14 in)
23.294 mm (0.9171 in) with rollers diam. 3.0 mm (0.12 in)
24.112 mm (0.9493 in) with rollers diam. 2.0 mm (0.08 in)
Desc./Quantity
19.975 mm (0.7864 in)
24.987 mm (0.9837 in)
Engine
ENG - 27