Table of Contents
Advertisement
iBurst Software Installatio
iBurst Software Installation n n n
iBurst Software Installatio
iBurst Software Installatio
This section shows the procedure to install iBurst software on your PC for utilizing iBurst Modem.
The procedure shall be done once before using it.
Installation for Windows XP
Installation for Windows XP
Installation for Windows XP
Installation for Windows XP
ATTENTION:
Don't choose "PCIC Compatible" mode of PC card controller in BIOS menu if
your PC has such menu. Please choose "Auto-Selected" or "CardBus/16bit" if
BIOS has it. There is a case that some models of PCs cannot drive iBurst
Modem due to BIOS or PC card driver problem.
1. Make sure to remove the iBurst Modem from your PC.
ATTENTION:
Don' ' ' ' t t t t plug
Don
plug the
the iBurst Modem
iBurst Modem into
Don
Don
plug
plug
the
the
iBurst Modem
iBurst Modem
2. Turn your PC on.
3. Insert the Software Utility CD provided by the network operator into your CD-ROM drive; or
execute the appropriate installation software.
4. iBurst Setup starts. Click the [Next >] button.
Kyocera Corporation
iBurst Modem Card Model (UTC) Manual
iBurst Modem Card Model (UTC) Manual
iBurst Modem Card Model (UTC) Manual
iBurst Modem Card Model (UTC) Manual
into your PC until
your PC until completion of installation.
completion of installation.
into
into
your PC until
your PC until
completion of installation.
completion of installation.
- 12 -
Revision 1.01 --- June.08.2006
Advertisement
Table of Contents
