Table of Contents
Advertisement
NOTE: This manual covers operations only for Windows Vista (x86).
iBurst Software Installatio
iBurst Software Installation n n n
iBurst Software Installatio
iBurst Software Installatio
This section shows the procedure to install iBurst software on Windows Vista (x86) for utilizing
iBurst Modem. The procedure shall be done once before using it.
ATTENTION:
Don't choose "PCIC Compatible" mode of PC card controller in BIOS menu if
your PC has such menu. Please choose "Auto-Selected" or "CardBus/16bit" if
BIOS has it. There is a case that some models of PCs cannot drive iBurst
Modem due to BIOS or PC card driver problem.
ATTENTION:
If you installed the iBurst software not for Windows Vista or you updated
Windows from XP or older, you have to uninstall the existing iBurst software
first. Otherwise performance and/or throughput through iBurst Modem may
be restricted.
1. Make sure to remove the iBurst Modem from your PC.
ATTENTION:
Don' ' ' ' t t t t plug
Don
plug the
the iBurst Modem
iBurst Modem into
Don
Don
plug
plug
the
the
iBurst Modem
iBurst Modem
2. Turn your PC on.
3. Insert the Software Utility CD provided by the network operator into your CD-ROM drive; or
execute the appropriate installation software.
4. When Windows prompts [User Account Control], click [Allow] to proceed installing.
Kyocera Corporation
iBurst Modem Card
iBurst
into your PC until completion of installation.
your PC until completion of installation.
into
into
your PC until completion of installation.
your PC until completion of installation.
- 10 -
iBurst
Modem Card Model (U
iBurst
Modem Card
Modem Card
Q34T-EE-003 Rev. 1.01 Jan.15,2007
Model (UT T T T C)
C) Manual
Manual
Model (U
Model (U
C) C)
Manual
Manual
Advertisement
Table of Contents
