Table of Contents
Advertisement
3200 Series
1. Installation and Basic Operation
1.1
What Instrument Do I Have?
Thank you for choosing this 3200 series Temperature Controller/Programmer.
A universal input accepts various thermocouples, RTDs or process inputs. Up to three 3216 outputs can be configured for control,
alarm or re-transmission purposes. Digital communications and a current transformer input are available as options.
The controller may have been ordered to a hardware code only or pre-configured using an optional 'Quick Start' code.
The label fitted to the side of the sleeve shows the ordering code that the controller was supplied to.
The last two sets of five digits show the Quick Code.
If the Quick Code shows *****/***** the controller was supplied with default parameters and will need to be configured when it
is first switched on.
This Manual takes you through all aspects of installation, wiring, configuration and use of the controller. Dimensions
General views of the controllers are shown below together with overall dimensions.
3216
Front View
48mm
(1.89in)
48mm
(1.89in)
Latching ears
Top View
1.2
What Firmware Do I Have?
The startup screen will display the firmware version immediately on power up. Version 2.09 is the standard controller that is
capable of communicating Modbus communications protocal. Version 2.50 is the standard controller that is capable of
communicating SPI communications protocol.
Firmware V2.09 (Modbus)
ACS 3216 Operators Manual
Side View
1.25mm
(0.5in)
IP65 Sealing Gasket
Panel retaining clips
90mm (3.54in)
Panel retaining clip
Firmware V2.50 (SPI)
3
Advertisement
Table of Contents
