6.1.4
To Select Access Level 3 or Configuration Level
Do This
1.
From any display press and hold
for more than 5 seconds
2.
Press
or
the passcode for Level 3
When the LEV3 GOTO view is
3.
shown, as in paragraph 1 above, press
to select 'Conf'
4.
Press
or
to enter the
passcode for Configuration level
5.
Press and hold
for more than 3
seconds
6.
Press
to select the required level
eg LEV 1
☺
A special case exists if a security code has been
configured as '0' If this has been done it is not necessary to
enter a code and the controller will enter the chosen level
immediately.
☺
When the controller is in configuration level the
ACCESS list header can be selected from any view by
holding down the
button for more than 3 seconds.
Then press
again to select 'ACCES'
10
The Display You Should See
To Select Level 3
Lev 3
go to
CODE
to enter
To Select Configuration level
Conf
go to
111
code
Conf
To Return to a Lower Level
Conf
go to
Lev1
Additional Notes
The display will pass from the current operating level, for
example, Lev 1 to Lev 3 as the button is held down.
(If no button is then pressed for about 50 seconds the display
returns to the HOME display)
0
C ODE
The Level 3 code is 11:
11
If an incorrect code is entered the display reverts to 'g o t o '.
The controller is now in the level 3 will then revert to the HOME
display
Note:
must be pressed quickly (within 2 seconds) before
the controller requests the code for level 3
0
(If no button is then pressed for about 50 seconds the display
C ODE
returns to the HOME display)
The configuration code is 111:
If an incorrect code is entered the display reverts to 'g o t o '.
The controller is now in Configuration level will now show
Conf
The choices are:
LEV 1
Level 1
LEV 2
Level 2
LEV 3
Level 3
C o n F
Configuration
It is not necessary to enter a code when going from a higher level
go to
to a lower level.
Alternatively, press
then press
The display will then flash 'ConF' for a few seconds and the
controller will then go through its start up sequence, starting in
the level selected.
Do not power down while Conf is flashing. If a power down
does occur an error message will appear.
3200 Series
and scroll to the A c c e s list header,
to select the required level.
ACS 3216 Operators Manual