DR30GS, DR30GFS, DR30GIS, DR30GIFS
Document # PG05-007
All tolerances ±1/16" (±1.6 mm) unless otherwise noted.
External handle
shown, some models
have integral handle
(see inside cover)
Product width:
29 7/8" (75.9 cm)
All specifications subject to change without notice.
Distinctive
All Gas Ranges
46 3/4" (118.7 cm)
28 9/16" (72.5 cm)
28" (71.1 cm)
26 1/8" (66.4 cm)
24" (61.0 cm)
1 1/8" (2.9 cm)
9" (22.9 cm)
Backguard*
Grates extend
1" above trim
DR30G[F]S:
Full stainless
steel side panels
DR30GI[F]S:
3 1/2" (8.9 cm)
partial stainless
steel side panels
(removable)
OvERALL DEPth DImENSIONS - SIDE vIEW
Part number
Description
AER30GLBG
Low profile (1 3/4 inch)
AERB30G03
3 Inch
AERB30G06
6 Inch
AERB30G09
9 Inch
1 Only backguard model AER30GLBG is compatible with a raised vent.
™
30" Wide
•
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
•
This appliance must be installed in accordance with the
accompanying installation instructions.
Front of open door
Front of handle
Front of knobs
Front panel
Rear of front panel
Backguard thickness
1
3" (7.6 cm)
backguard*
DR30GI[F]S:
1/4" (6.4 mm)
thick top trim
1
* See table for compatibility
35"
(88.9 cm)
to
37"
(94.0 cm)
2
Standard on models DR30GIS, DR30GIFS
Optional on models DR30GS, DR30GFS
Optional on models DR30GS, DR30GFS
NOT compatible with models DR30GIS, DR30GIFS
Standard on models DR30GS, DR30GFS
NOT compatible with models DR30GIS, DR30GIFS
Optional on models DR30GS, DR30GFS
NOT compatible with models DR30GIS, DR30GIFS
AvAILAbLE bAckGUARDS
www.dacor.com
PLANNING
warning
NOTE: Models DR30GS and
DR30GFS are not compatible
with a raised vent.
6" (15.2 cm)
backguard*
1 3/4" (4.4 cm) backguard*
Compatibility
Phone: (800) 793-0093
Revised 04/04/13 Page 1/5
GUIDE