Digital Tag - Sharp JW10 Driver Manual

Advantech WebAccess Device Driver Guide
09000
12. Enter a Description. This will help identify this tag to Users and
Operators. For example, enter Boiler #1 Steam Flow.
13. Optionally enter, Scaling, Span Hi, Span Low, Engineering Units, and
Alarms; enable data logging, etc.
14. Press Submit.
4.2

Digital Tag

This example is to configure a Tag that writes a Digital Output (Address DO
40)
15. Select the Sharp JW10 Device.
16. Select Add Tag.
17. From Parameter Pull Down List Select DO. This will configure an
Analog Input. Wait for the Page to update.
18. Optionally, select ALARM from the ALARM pull down list. Wait for the
Page to update with a PINK highlight around alarm (an additional
Alarm Fields at bottom of page).
19. Enter a Tagname users can use to identify this Analog Input
measurement. For example, if this is a Flow measurement, enter DO.
20. Edit the Address to the actual address. From the example, Enter:
0040
21. Enter a Description. This will help identify this tag to Users and
Operators. For example, enter DO-Relay.
Version 6.0 rev 0 Advantech Corp., Ltd.
Sharp JW 10 Serial
page 12