Table of Contents
Advertisement
Chapter 3: Device Configuration
Chapter 3: Device Configuration
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter contains information which will assist you with accessing the MWR via local web
interface and using the available configuration options.
The web interface offers an incomplete alternative to configuring a MWR device when the network
lacks a Network DHCP server. The recommended device configuration method is to use the
MOTOMESH MeshManager Device Manager application, see the MOTOMESH MeshManager Users
Guide for additional details.
Accessing the Device Administration Web Pages
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The procedure below describes how to access the MWR device web page.
Procedure 3-1 Accessing the MWR Device Administration Web Interface
Find the IP address assigned to the MWR SBC prior to accessing the device administration web interface.
6
You can use MeshManager's Device Manager to access the MWRs SBC IP address. To do this, double-
click on the MWR in MeshManager's Device Tree, and then view the resulting SBC IP address
information shown in the top right pane.
Note that by default, the device's addressing mode will be set to Network DHCP
which means that the device will use the address assigned to it by the Network
DHCP Server.
If a fixed address was provided by the Network Operator in MeshManager, then that
IP address will be used by the MWR instead of the derived address when the
Statically Provisioned option is in effect.
When the IP address is known, open your web browser and enter the IP address of the MWR SBC.
7
For example, if the MWR SBC address is 10.128.32.1, then the web page would be found at
http://10.128.32.1/.
6881011Y53-O September 2005
.
.
.
.
.
.
3-8
Chapter
3
Advertisement
Table of Contents
