Table of Contents
Advertisement
The longitude, latitude, and altitude values should be entered to a precision of 5
digits following the decimal point.
Device Connectivity Testing
When a MiSC has been setup on the network, verify connectivity to the device using the following
procedure:
Procedure 2-2 Testing MWR Device Connectivity
Apply power to the device, the device should be operation in 60 to 120 seconds
1
Obtain the MEA and 802.11 MAC addresses for the device subcomponents that were recorded in the
2
MAC Address Table earlier in this manual. The address will be in the format 02-05-12-30-xx-yy.
3
Within MeshManager's Device Manager screen, right-click on the appropriate MWR device in the
Device Tree and select the Ping Device option.
Check for a successful response to the Ping command in the Named Device results dialog box. A
4
successful response to the ping commands verifies connectivity to the device (MWR).
Repeat steps 1-4 for additional MWR devices.
5
6881011Y53-O September 2005
MOTOMESH 1.0 Mesh Wireless Router Users Guide
2-7
Advertisement
Table of Contents
