Equipment Specification - Motorola Motomesh 1.0 User Manual

Chapter 2: MWR Device Installation
For a MOTOMESH deployment, a permanent power source for each MWR must be provided. All
infrastructure devices require professional installation to ensure that the installation is performed in
accordance with FCC licensing regulations
Infrastructure devices are fitted with two mounting brackets designed to be attached to light poles and
other probable installation sites. Alternate mounting hardware is available for mounting directly to
posts or structures that are too large for the standard brackets. Optional remote antenna mount
hardware is also available for use with the alternate mounting hardware.

Equipment Specification

The specifications listed in the following table apply for all Infrastructure devices.
Table 2-2
Characteristic
Output Power
RF Modulation
Operating Frequency (GHz)
Maximum Burst Data Rate
Spectrum Used
The following list defines the standard hardware components for IAPs and MWRs.
•
•
•
•
•
The Network Operator must supply the following equipment.
•
•
•
•
6881011Y53-O September 2005
MOTOMESH Infrastructure Device Radio Characteristics
2.4GHz
802.11 b/g
23 dBm
CCK/OFDM
2.412-2.462
54 Mbps
20 MHz
Device Enclosure with 4 N-type Female Antenna Connector
120V A/C Power Cable with a NEMA 5-15 plug
4 Antennas with N-type Male Antenna Connector
Weatherproof RJ-45 Connectors
Mounting Bracket (Standard and Optional)
Mounting Location
Power Source (120V/240V A/C 50/60 Hz)
Ethernet connection between the IAP and the MiSC
(2) 7/16 inch wrenches
2.4GHz
MEA
24 dBm 23 dBm
QDMA OFDM
2.40-2.48 4.945-4.985
6 Mbps 18 Mbps
60 MHz 10 MHz
2-2
4.9GHz 4.9GHz
802.11 MEA
24 dBm
QDMA
4.950-4.965
6 Mbps
20 MHz