Using The Appliance - TEFAL Easy Fruit User Manual

USING THE APPLIANCE

• Place the juice collector (E) on the body of the appliance (see
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is
properly clipped onto the drive shaft (J) (see
• Fit the pulp collector (G) on the rear of the appliance (see
• Fit the cover (C) on the appliance, spout to the rear (see
• Push the safety clamp (H) to the rear until it locks into place. You will
hear an audible "click" (see
• Slide the pusher (A) into the feed tube (B) aligning the groove on the
pusher with the small ridge in the feed tube (see
• The juice jug (L) has a foam separator (N) that keeps the foam in the
jug when you pour the juice into a glass. If you do not want to separate
the foam, remove the foam separator (N).
• Place the juice jug (L) under the pouring spout in front of the appliance
(see Fig. 6).
• Plug in the appliance.
• To start the appliance, use the control knob (I).
• Insert the fruits or vegetables through the feed tube (B).
• The fruits and vegetables must be inserted only while the motor is
running.
• Do not press too hard on the pusher (A). Do not use any other utensil.
NEVER push with your fingers.
• When you have finished, stop the appliance by turning the control knob
(I) to 0 and wait until the sieve (D) stops completely.
• When the pulp collector (G) is full, or the juice flow slows down, empty
the pulp collector and clean the sieve and the cover.
• Remove the "juice collector + sieve" assembly by pulling vertically
using both hands (see
Fig. 5).
Fig. 7 and 8).
Fig. 2).
Fig.
Fig. 4).
Fig. 5).
Fig. 1).
3).
EN
57