Copying Routes - JRC JR-8600 Instruction Manual

4.5.4

Copying routes

The route that was created can be copied on to a different route number.
The waypoint that is used by the shared active route and is sent from ECDIS and is saved in
number 101 is overwritten automatically when the next route is sent. Routes that are to be saved
must be copied on to numbers between 1 and 100.
The waypoint of a temporary route that is saved under number 102 is cleared when another
temporary route is created or the power is turned off. To save the route, the route must be copied
on to a number between 1 and 100.
Routes of consecutive numbers can be copied in bulk.
When no free area is available, a route can be overwritten. However, the route that is being
executed cannot be overwritten.
Select a copy source and specify a copy destination number.
When a temporary route or a shared route is to be copied, the waypoints must also be copied.
Procedure
 
1.
Copy source
Copy destination
2. Tap "COPY ORG" and enter a number of a starting point and an ending point of the copy
source.
The input method is outlined below.
(1) MANUAL: Enter an ending point and a starting point.
(2) ROUTE LIST: Select from the route list.
When copying one point only, enter the same number for a starting point and an ending point.
(1) MANUAL input
a) Tap .
Item
FROM
TO
(2) Selecting from a ROUTE LIST
a) Tap .
b) Tap a starting point and an ending point on the route list.
4-28
Description
Set a starting number.
Set an ending number.
Total number of routes