Executing A Route; Executing A Route By Selecting From A Route List - JRC JR-8600 Instruction Manual

4.6

Executing a Route

 A registered route or a temporary route can be executed.
 The following route selection methods are available.
(1) Select a route from a route list.
(2) Select a waypoint by using the GOTO key.
(3) Select a route by using the GOTO key.
(4) Select a temporary route by using the GOTO key.
 A route cannot be executed at the position exceeding North latitude/South latitude 89 degrees.
 For the route width, arrival radius, planned ship speed of the temporary route that was created
by GOTO, the initial values of the route are used. For the setting of route initial values, refer to
"4.5.7 Setting route initial values".
 The waypoint is updated when the ship arrives at the arrival circle.
4.6.1

Executing a route by selecting from a route list

A route can be executed by selecting from a route list.
Procedure
 
1.
2. Set each item.
Item
ROUTE
LEG CHANGR
DIRECTION
NAVIGATION
Description
Displays the route number to be executed.
Select a waypoint update method.
AUTO: When the ship arrives at the arrival circle (normal route) or WOL
(TSC route), the waypoint is updated automatically.
is displayed.
"WPT CHANGE" is displayed for 5 seconds.
MANUAL: When the ship arrives at the arrival circle (normal route) or
WOL (TSC route), the effect is notified to the user. The waypoint is to be
updated manually.
is displayed.
"PLEASE PUSH "OK" AND CHANGE A ROUTE is displayed. Tap "OK".
The waypoint is updated.
Set an order of the waypoints to be executed.
ORDER: Executes the route in the order of waypoints.
REVERSE: Executes the route starting from the last waypoint.
Executes the route.
START: Executes the route.
END: Ends the route.
4-33