Siemens SICAM P35 Manual page 26

Operation and Display
4.3 Key Definition
Key Setting Parameters
1. Key functions at parameter setting mode
Key symbol
Function
1.Press "
again to alter parameters. Pressing "
26
▲
a) "▲" to switch digit or flip over;
b) "▼" to move cursor or flip over.
" once after adjusting parameters with "▲" and "▼" to display "Sure", and press "
Example 15:
This screen shows reactive pulse constant items.
At cyclic display mode, press "▲" or "▼" to enter key display
mode, press "
to switch to reactive pulse constant items.
In the figure, reactive constant=5,000 imp/kWh.
Example 16:
This screen shows Device ID display items.
At cyclic display mode, press "▲" or "▼" to enter key display
mode, press "
to switch to Device ID display items. Device
ID=000000000001.
Example 17:
This screen shows error code display items.
At cyclic display mode, press "▲" or "▼" to enter key display
mode, press "
to switch to fault code display items. "E" means fault prompt,
the 7 bits from right to left mean respectively phase A loss,
phase B loss, phase C loss, voltage phase inversion, phase C
reverse, phase B reverse, and phase A reverse. For example,
"E0110001" means phase B and phase C loss and phase C
reverse fault occurs.
▼
a) Press "
setting screen.
b) Press "
setting.
c) Press "
rameter setting
" immediately after "Sure" appears will cancel current alteration.
SICAM P35 P36, 3-phase Multi-Function Power Meter, User Manual
" to switch to area B, and press "▲" or "▼"
" to switch to area B, and press "▲" or "▼"
" to switch to area B. Press "▲" or "▼" again
" and " " at the same time to enter
" to enter next menu or "confirm" parameter
" to return to previous menu or "cancel" pa-
1
.
E50417-H8940-C562-4, Release Date 06.2018
" once