Required Equipment - NEC NEAX2000 IVS User Manual

4. REQUIRED EQUIPMENT

Table 2-2 shows the required equipment for establishing the Remote PIM System.
EQUIPMENT NAME
SN1308 PIM P-A (PIM Q-UA)
SN1420 PIMAB-A
PN-DAIA (DAIA Card)
PN-DAIB (DAIB Card)
PIM N-UB
CHAPTER 2
Page 6
Revision 2.0
Table 2-2 Required Equipment
Port Interface Module for Small Platform System/Remote PIM system
(remote site)
A PIM provides 13 card slot for common control, Line/Trunk cards. It
also houses a AC/DC power supply and optional batteries for protection
from short-term power interruption.
Three champ connectors for line/trunk (LTC0 to 2) and a connector for
Power (PWR) are located at the lower front side of the PIM.
Port Interface Module (PIM) for 1000 IVS/Remote PIM system (remote
site).
A PIM provides 10 card slots for common control, Line/Trunk, and
Application Processor (AP) cards. It is also houses a AC/DC Power Sup-
ply and batteries for protection from short-term power interruption.
Two champ connectors for line/trunk (LTC0 to 1) and a connector for
Power (PWR) are located at the lower front side of the PIM.
Interface card for Remote PIM System at main site
This card provides 1.5 Mbps (24 channel) digital interface, firmware
processor, and BUS interface; 1 through 3 DAIA cards must be provided
at main site, which corresponds to the number of the remote site.
Interface card for the Remote PIM System at remote site
This card provides 1.5 Mbps (24 channel) digital interface, firmware
processor; 1 card is required per Remote PIM at the remote site.
Port Interface Module for 128/512 port systems/Remote PIM system.
This PIM can be a Remote PIM or main office PIM.
This PIM provides 19 slots for common control line and trunk cards. This
PIM houses an AC/DC power supply and optional batteries for short-term
power interruption.
Three champ connectors for line/trunk (LTC0 to 2) and a connector for
Power (PWR) are located at the lower front side of the PIM.
ND-46550 (E)
DESCRIPTION