Radio Shack PRO-2055 Owner's Manual page 43

1,000 channel multi trunking mobile/base scanner

Hide thumbs Also See for PRO-2055:

20-428 Owner's Manual

1. Press PROG.

Note: You can only lock out talk group IDs when the scanner is in the closed mode (see "Open and

Closed Modes").

2. Press TRUNK.

3. Press FUNC, /¥ or ¥/ to move to the desired bank.

4. Press /¥ or ¥/ to select the ID memory.

5. Press L/OUT to lock out the ID. lo changes to LO.

6. To remove the lockout from a trunking ID, manually select the ID memory, and press L/OUT. LO

changes to lo.

You can confirm the ID code while the scanner shows the text when the received signal is a voice

channel.

1. Press TEXT while the scanner is receiving the voice channel and indicating the text name. The ID

code appears as MOT:XXXXXX, etc.

2. Press TEXT again to cancel.

delay function in ID indication mode

You can set the ID delay function separate from the channel delay.

1. Press FUNC then •/DELAY while you are programming the trunked ID. Use Up/Down keys to

set ID Delay. ENTER key saves. 2.0 seconds appears.

2. Press /¥ or ¥/ to select None, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, or 4.0 seconds.

3. Press ENT.

Note: When activated, ID delay watches the control channel command for the delay time when the

signal disappears from the voice channel.

reviewing locked-out talk group IDs

You cannot clear all lockouts from a talk group at the same time.

Page 43 of 50