Advertisement
step. Some scanner designs do this without showing the correct step in the display. This scanner will
show the actual tuned frequency in the display. Because steps are so close together, the audio
quality will not be affected by the offset.
search bank: SR5 amateur band
Receive mode: FM
Group
Frequency (MHz)
0
28.0000 – 29.7000
1
50.0000 – 54.0000
2
144.0000 – 148.0000
3
222.0000 – 225.0000
4
420.0000 – 450.0000
5
1240.0000 – 1300.0000
search bank: SR6 programmable limit search
Receive mode: FM or AM (Default setting)
searching active frequencies in a range
You can program the desired frequency range for a search.
1. Repeatedly press SRCH to select SR6.
2. Press PROG then SRCH. Enter SR6 Search Range Limits: appears and the cursor blinks L on the
third line for the lower-end limit frequency.
3. Use the number keys and •/DELAY to enter the desired lower-end limit frequency (including the
decimal point).
4. Press ENT to set the frequency. The cursor moves to U. If the entered frequency is incorrect,
Invalid Freq. briefly appears.
5. Enter your desired upper-end frequency and press ENT.
6. Press SRCH to start searching.
7. Rotate SQ clockwise and leave it set to a point just after the rushing sound stops. When the
scanner finds an active frequency, it stops searching.
Notes:
Step (kHz)
5
5
5
5
12.5
6.25
Page 22 of 50
20-428 Owner's Manual
Advertisement
