Advertisement
20-428 Owner's Manual
install your scanner
You can mount your multi Trunking scanner in your vehicle, install it for mobility, or install it as a
base station.
mounting your scanner in your dashboard
If you are unsure about how to install your scanner in your vehicle, consult your automobile
manufacturer, dealer, or a qualified installer. Before installing, confirm your scanner fits in the
desired mounting area and you have all the necessary materials. Your scanner requires a 2 x 7 1/8 x
5 5/16 inch (50 x 180 x 135 mm) mounting area.
1. Remove the four rear screws and pull off the black case before installing your scanner.
2. Install the DIN sleeve into the opening in your dashboard, lip facing out.
3. Push out the top and bottom tabs to hold the sleeve firmly in place.
4. Slide the scanner into the sleeve until it locks in place.
Notes:
• To remove your scanner from the DIN sleeve, insert the two keys straight into the scanner's front
panel. Then, remove the scanner by pulling front panel.
• When mounting in your dashboard, you will need to connect an external antenna and an external
speaker.
mobile mounting in your vehicle
You can mount your scanner under the dashboard, or on top of it, using the mounting bracket.
1. Attach the three protective rubber feet to the mounting bracket when you use the scanner on a
flat surface. Do not use them when you mount the bracket with screws.
2. Use the supplied mounting bracket as a template to mark positions for the two mounting screws.
3. At the marked positions, drill holes slightly smaller than the screws.
4. Remove the paper backing from each washer and stick one inside of each bracket's ear, aligning
the washer's hole with the bracket's hole.
5. Attach the mounting bracket to your vehicle's surface using the supplied screws and lockwashers.
Page 3 of 50
Advertisement
