Radio Shack PRO-2055 Owner's Manual page 40

1. Press PROG then TRUNK.
2. For each bank you want to program, repeatedly press FUNC. Then /¥ or ¥/ to select the bank.
3. Press FUNC. Then press 8. Size Code Setting appears.
4. Enter the size code supplied with the Type I system information, referring to the instruction that
appears on the display. If the information was not supplied, try the following common fleet maps.
Block
1 2
0 S11 S4
1 S11 S4
2 S11 S4
3 S11 S4
4 S11 S4
5 S11 S4
6 S11 S4
7 S11 S4
Block
9 10
0 S4 S0
1 S4 S0
2 S0 S0
3 S0 S0
4 S0 S0
5 S0 S0
6 S0 S4
7 S0 S4
5. Press ENT for each entry. If you make a mistake, press CLEAR and enter the correct size code.
Notes:
• The default setting of the bank is for Motorola Type II. However, if you set Type I and you want to
return to Type II, enter 15 at Step 4.
• To confirm the input, repeat Steps 1-5 and press ENT. Each time you press ENT, you confirm the
size code. If you find an error, press CLEAR and begin again at Step 1.
6. Press SCAN to start scanning.
talk group IDs
Size Code
3 4 5
S4 S12 S4
S4 – S4
S4 S4 S12
S4 S4 –
S4 S4 S4
S4 S4 S4
S12 S4 S4
– S4 S4
Size Code
11 12 13
S4 S0 S3
S0 S0 S3
S0 S0 S11
S0 S0 S4
S0 S0 S4
S0 S0 S0
S0 S0 S0
S0 S4 S0
Page 40 of 50
20-428 Owner's Manual
6 7 8
S3 S10 S1
S10 S10 S1
S4 S11 S2
S4 S4 S2
S12 S4 S3
– S4 S3
S12 S4 S4
– S4 S4
14 15 16
S4 S4 S3
S3 S4 S10
S10 S4 S10
S4 S11 S11
S4 S11 S0
S4 S0 S0
S12 S12 S12
– – –