Advertisement
20-428 Owner's Manual
2. Select the search bank in which you want to clear all locked-out frequencies.
3. Press FUNC then press L/OUT. Lockout list appears.
4. Press FUNC then 6. Clear entire list ? Press 1 to clear all, any other key aborts appears. Press 1
to clear all locked-out frequencies. List cleared. appears for about 2 seconds. Press any key other
than 1 to cancel clear.
priority
In addition to the 1,000 programmable memory channels, the scanner has one priority channel.
With the priority feature, you can scan through programmed channels and still not miss an
important or interesting transmission on a specific channel. When priority is turned on, the scanner
checks that channel every 2 seconds, and stays on the channel if there is activity until the activity
stops.
Notes:
• The priority feature does not operate while the scanner receives a trunking voice channel or
during trunking delay time. Therefore, the priority check seems random during peak hours.
• If you program a weather channel as the priority channel, the scanner stays in the priority
channel only when the scanner detects the weather alert tone.
• This scanner cannot set a channel as the priority channel if the channel's receive mode is MOT,
ED, or LTR.
• If you press PAUSE while the scanner receives the priority channel, the scanner displays ***
PAUSED *** and stays on the priority channel even after the transmission finished.
To program a frequency in the priority channel:
1. Press MAN.
2. Use the number keys to enter the channel number which contains the frequency you want to
program as the priority channel. Then press MAN again.
3. Press FUNC then PRI. The display blinks.
To program the priority channel directly:
1. Press PROG.
2. Press PRI.
3. Enter the frequency you want to enter into the priority channel, then press ENT.
Page 32 of 50
Advertisement
