Advertisement
20-428 Owner's Manual
10. Press SCAN to start scanning.
Notes:
• If you made a mistake in Step 4, Invalid ID value appears and the scanner beeps when you press
ENT. Start again at Step 3.
• You can enter either a decimal or AFS code for ED (EDACS) IDs. The default setting is decimal ID
entry. When you press FUNC then 2, AFS Format appears for about 2 seconds. Now you can enter
the ID code with AFS format.
If you entered an ID code that is already stored in another ID channel, Dupl. ID of X-XX appears. If
you want to store the ID code, press ENT. To cancel the operation, press CLEAR.
talk group ID hold
You can set your scanner to follow a trunking signal that you want to track during scanning. While
the scanner is stopped on a voice channel (VC appears), hold down TRUNK until ID hold ON.
appears.
When ID hold is activated and the scanner receives a voice channel, the scan indication S at the first
digit in the top line changes to H
To release ID hold, press SCAN or TRUNK.
Trunking an ID sub-bank on or off
Follow these steps to turn the ID sub-bank on or off during the program mode:
1. Press TRUNK repeatedly to select the desired sub-bank.
2. Press FUNC then 1 to turn the sub-bank on if it is off or off if it is on.
Follow these steps to turn the ID sub-bank on or off during the scan mode:
1. Press FUNC while the scanner is stopped on a voice channel transmission.
2. Press TRUNK. The display indicates which sub-bank is turned on or off, and the active sub-bank
number flashes.
3. Press FUNC and the number of the sub-bank you desire to turn on or off. For example to turn
sub-bank 4 on or off, press FUNC. Then press 4.
locking out talk group IDs
Page 42 of 50
Advertisement
