Advertisement
20-428 Owner's Manual
You can copy a frequency into a specified channel when the scanner stops on that frequency during
search mode or manual tuning.
1. Press FUNC then PROG when you find a frequency. Store in ChXXX ? appears on the bottom line.
After about 1 second, the frequency to be copied flashes.
2. Press the desired bank and the channel number where you want to store the frequency. The
display indicates the bank and channel number. After about 1 second, the frequency to be copied
flashes.
3. Press ENT. All the conditions such as receive mode and delay condition are copied onto the
channel. Channel Stored! briefly appears. The scanner automatically returns to search mode.
If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3 times
after you press ENT. Dupl.Freq. ChXXX appears. If you want to copy the duplicate frequency
anyway, press ENT, or if not, press CLEAR to cancel.
copying a frequency into an empty channel within a bank
You can copy a frequency into a vacant channel in a specified bank when the scanner stops on the
frequency during search or tune mode.
1. Press FUNC then ENT when you find a frequency you want to copy. Bank 9 Store? appears.
2. If you want to copy the frequency into bank 9, press ENT. It is stored in the first available vacant
channel in the bank. Or, press your desired bank number to store, then press ENT. Channel Stored!
appears for 2 seconds. All the conditions such as receiving mode and delay condition are copied on
the channel. After about 2 seconds, the scanner automatically returns to search mode.
3. If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3 times
after you press ENT. Dupl.Freq. ChXXX appears on the third line. If you want to copy the duplicate
frequency anyway, press ENT, or if not, press CLEAR to cancel.
copying a frequency into the priority channel
You can copy a frequency into the priority channel (see "Priority") when the scanner stops on the
frequency during Search, Scan, Manual, Tune, or WX mode.
Press FUNC then PRI when the frequency appears. The display flashes twice and the frequency is
copied to the priority channel.
Signal Stalker II
Page 26 of 50
Advertisement
