Table of Contents
Advertisement
The System Touch is a touchscreen
device with a 4.3 in. color LCD display that acts as a front-end
interface
to
controllers
on a BACnet network.
To screens
specific
to the
controller
To Home
screen
To previous
screen
To Alarm
Manager
screen
To system
To screens
To setup
screens
atarms
for scheduling
for the system
or
the equipment
touchscreen
The System Touch has built-in
temperature
and humidity
sensors.
You can use their values to control
equipment.
You can also wire an external thermistor
to the System Touch and use its value instead
of the built-in
temperature
sensor's
value.
You can install and run the System Touch with only its built-in
system screens,
or you can create
a custom
touchscreen
file in ViewBuilder.
This requires
that you create custom
screens
in ViewBuilder,
and then save the
touchscreen
(.touch) file. See "Working
with System Touch screens"
in ViewBuilder
Help.
NOTE To use custom
screens,
the System Touch must have v2.00-015
or later firmware.
Carrier
Proprietary
and Confidential
1
System Touch
CARRIER CORPORATION
@2015
Installation
and Setup
Guide
All rights
reserved
Advertisement
Table of Contents
Need help?
Do you have a question about the System Touch and is the answer not in the manual?