Vendlet V5 Quick Manual

VENDLET
V5 and V5+
The button works
as a stop button
WHEN VENDLET IS USED AS SIDE RAIL
1. The surface of the bed must be falt and horizontal.
2. Remove the plastic plates and hang them on the support bar.
3. Double-click the button to activate the VENDLET system. The VENDLET
system produces an acoustic signal and the green diode over the power
symbol turns on. When the hand control has been inactive for 90 seconds,
the system is off again.
4. The patient is repositioned by operating the hand control.
Tighten the sheet on
the red bar
Slacken the sheet on
the red bar
Raise
the red bar
Lower
the red bar
Power w.
illuminated diode/
stop
5. After repositioning the patient; raise the bars if these have been lowered.
6. Attach the plastic plates – 2 on each side.
See also the side rail guide.
During the procedures always stay focused on the patient.
VENDLET must be used
and installed in accordance
with the manual
T: +45 9631 0050 • M: vendlet@vendlet.dk • W: vendlet.com
QUICK GUIDE
Tighten the sheet on
the blue bar
Slacken the sheet on
the blue bar
Raise
the blue bar
Lower
the blue bar
Under bed light
(accessory)
Scan the QR code
to watch instruction
videos