Table of Contents
Advertisement
Getting your baby monitor ready for use
EN
+
+
+
+
+
+
+
+
10
Battery operated use
1 Open the battery compartment by turning the cover (A-12)
to the left (1 OPEN), using the palm of your hand.
Take off the cover.
2 Insert four 1.5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied; we recommend Philips Alkaline batteries).
3 Put the battery compartment cover (A-12) back in place.
Close the compartment by turning the cover (A-12) to the
right (CLOSE 2), using the palm of your hand.
Note:When the units are switched off, in case of battery
operated use, the batteries still discharge slowly.
§ The baby unit is now ready for battery operated use!
Parent unit
1 Open the battery compartment by sliding the cover (B-12)
downwards.
2 Insert the two 1.2V AAA size
(supplied), noting the + and – configuration inside the battery
compartment.
3 Put the battery compartment cover (B-12) back in place.
Close the compartment by sliding the cover (B-12) upward
until it clicks in position.
4 Connect the AC power adapter (B-14) of the charging base
(B-15) to a wall outlet.
NiMH
rechargeable batteries
Advertisement
Table of Contents
