Advertisement
Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
1..Modes
User mode
PC mode
Mode
User mode
For normal use.
Used for communication between the trans-
PC mode
ceiver and PC.
Data programming
Used to read and write frequency data and
mode
other features to and from the transceiver.
Used to check the transceiver using the PC.
PC test mode
This feature is included in the FPU.
2..How.to.Enter.Each.Mode
Mode
User mode
Power ON
PC mode
Received commands from PC
SYSTEM SET-UP
A personal computer, programming interface (KPG-36/36A),
and FPU (programming software) are required for programming.
(The frequency and signalling data are programmed for the
transceiver.)
YES
NO
Delivery
REALIGNMENT
Data programming mode
PC test mode
PC tuning mode
Function
Operation
Frequency range (MHz)
RF power
TX/RX 440~470
1.2W
KRA-23 or KRA-27
Optional antenna
3..PC.Mode
3-1..Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-36/36A, USB adapter
(KCT-53U)) and FPU (programming software).
The programming software can be used with a PC. Figure
1 shows the setup of a PC for programming.
3-2..Connection.Procedure
1. Connect the transceiver to the personal computer with the
interface cable and USB adapter (when the interface cable
is KPG-36A, the KCT-53U can be used).
Note:
• You must install the KCT-53U driver in the computer to use
the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the first time,
plug the KCT-53U into a USB port on the computer with
the computer power ON.
2. When the POWER is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
transceiver enters PC mode.
When data is read from the transceiver, the red LED lights.
When data is written to the transceiver, the green LED
lights.
TK-3260EX
Type
TK-3260EX: E
3
Advertisement
