Advertisement
Test.Equipment.Required.for.Alignment
Test.Equipment
1.
Standard Signal Generator (SSG)
2.
RF Power Meter
3.
Deviation Meter
4.
Digital Volt Meter (DVM)
5.
Oscilloscope
6.
High Sensitivity
Frequency Counter
7.
DC Ammeter
8.
AF Volt Meter (AF VTVM)
9.
Audio Generator (AG)
10. Distortion Meter
11. Spectrum Analyzer
12. Tracking Generator
13. 16Ω Dummy Load
14. Regulated Power Supply
nAntenna.connector.adapter
The antenna connector of this transceiver uses an SMA
terminal.
Use an antenna connector adapter [SMA(f) – BNC(f) or
SMA(f) – N(f)] for adjustment. (The adapter is not provided
as an option, so buy a commercially-available one.)
n.Battery.Jig.(W05-157-00)
Connect the power cable properly between the battery jig
installed in the transceiver and the power supply, and be sure
output voltage and the power supply polarity prior to switch-
ing the power supply ON, otherwise over voltage and reverse
connection may damage the transceiver, or the power supply
or both.
Note: When using the battery jig, you must measure the
voltage at the terminals of the battery jig. Otherwise, a slight
voltage drop may occur within the power cable, between the
power supply and the battery jig, especially while the trans-
ceiver transmits.
ADJUSTMENT
Frequency Range
136 to 520MHz
Modulation
Frequency modulation and external modulation
Output
–127dBm/0.1µV to greater than –47dBm/1mV
Input Impedance
50Ω
Operation Frequency
136 to 520MHz
Measurement Range
Vicinity of 10W
Frequency Range
136 to 520MHz
Measuring Range
10mV to 10V DC
Input Impedance
High input impedance for minimum circuit loading
DC through 30MHz
Frequency Range
10Hz to 1000MHz
Frequency Stability
0.2ppm or less
5A
Frequency Range
50Hz to 10kHz
Voltage Range
1mV to 10V
Frequency Range
50Hz to 5kHz or more
Output
0 to 1V
Capability
3% or less at 1kHz
Input Level
50mV to 10Vrms
Measuring Range
DC to 1GHz or more
Center frequency
50kHz to 600MHz
Output Voltage
100mV or more
Approx. 16Ω, 3W
5V to 10V, approx. 3A
Useful if ammeter equipped
TK-3260EX
Major.Specifications
+ Terminal(Red)
- Terminal(Black)
Schematic diagram
S
–
+
+
–Terminal
(Black)
Power
Power
cable
supply
+Terminal
(Red)
7
Advertisement
