Using Slip; Figure 5-19. Ip Configuration Menu - SMC Networks SMC6516TF User Manual

Using SLIP

SLIP (Serial Line Internet Protocol) is a simple protocol that is
used solely for encapsulating and framing IP packets that are
being transmitted over serial lines. To set up for out-of-band
management via SNMP using SLIP, proceed as follows:
1. From the Main Menu, type 1 to select the Switch
Configuration Menu.
2. From the Switch Configuration Menu, type 2 to select the IP
Configuration Menu.
________________________________________________________
>>>> IP Configuration Menu
1. Automatic Selection of IP address (DHCP).. [
2. Switch IP Address................. [ 170.129. 71.199 ]
3. Default SNMP Manager IP Address... [ 170.129. 71.170 ]
4. Default Gateway IP Address........ [ 170.129. 71.
5. Subnet Mask....................... [ 255.255.255.
6. SLIP Enable....................... [
7. SLIP IP Address................... [ 179.129. 72.199 ]
8. SLIP Subnet Mask.................. [ 255.255.255.
<ESC> To Exit Menu
Enter Selection:
________________________________________________________
3. From the IP Configuration Menu, enable SLIP. Then, enter
the SLIP IP address followed by the SLIP subnet mask.
4. Reset the switch.

Figure 5-19. IP Configuration Menu

C
ONFIGURING AND
<<<<
M
ONITORING
ON]
1 ]
0 ]
Disabled ]
0 ]
5-35