Page 2
AL570 & AL570XL Chair Plow ..3 OPERATING YOUR LIFT Dock ‘N’ Lock: AL570 & AL570 XL 3 General Operation .........3 TROUBLESHOOTING AL010/050 and AL030 Micro Lifts ..6 EXPLODED VIEWS AL570 & AL570XL Lifts ......7 AL030 ............Using a Swing-Away ......8 AL010/050 ..........
Page 3
SECTION 1 : OWNER Insert key and switch to ‘ON’ position.Press ‘DOWN’ on toggle switch. The platform will unfold. Continue to lower until platform reaches the ground and becomes level. over-lower to the point where the vehicle begins to rise. This will damage the lift. Drive slowly, stopping when the drive wheels fall between the platform bars on the side or center depending on the lift and chair model.
Page 4
SECTION 1 : OWNER Depending on your lift model and the type of securement device it uses, you may wish to raise the platform halfway, using the ‘UP’ toggle switch, in order to avoid having to bend over while you attach straps or flip the chair’s armrest out of the way of the hold-down arm.
Page 5
When the chair is unloaded, press ‘UP’ and the platform will automatically fold. (Except verify the chair or AL010/050 and AL030). scooter is held firmly in place prior to transport. run the lift fully to the top for transport. The lift will make a...
Page 6
SECTION 1 : OWNER models require the platform to be folded and unfolded manually. The locking mechanism consists of a pin and keeper plate, which must be disengaged before unfolding. Simply hold the platform firmly and lower it approximately 2” to allow the platform to disengage and unfold.