Omron V740 Series Operation Manual page 10

2. Click the Make Select button. A query
designed to read data from the antenna
connected to UHF1 appears in the center
pane.
3. Place the tag to be read within the detection
zone of the antenna.
4. Click the Submit Query button to read tag data.
Query results appear in the bottom pane.
Settings Page
Use the Modify Settings page to change network
settings.
1. Click the Settings link on the navigation menu.
The Modify Settings page appears.
2. Enter the required settings.
3. Click the Save button to save the new settings.
IMPORTANT: Do not disconnect power until
the save process is complete.
The new settings DO NOT take effect until the
Reader is restarted by rebooting the Reader
(see Restarting the Reader on page 12).
Instructions for Modifying the Settings
Changing these parameters changes the Readers
settings used on startup. Both radio settings and
V740 RFID READER ANTENNA
OPERATION MANUAL
NOTE. SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
10 of 27
network settings can be modified. Care must be
taken to use correct values or you might be unable
to connect the Reader without restarting into safe
mode.
Static network settings are ignored when in DHCP
mode, and DHCP related settings are ignored
when in static IP mode. Please note that your
network needs to have properly configured DNS
servers if you wish to connect to the Reader via its
hostname. Usually when using DHCP, the DHCP
server will add the hostname to the DNS server's
database.
Device Settings
UHF Output power in dBm. This
UHF Power
setting must be adjusted carefully
(dBm)
to comply with FCC regulations.
Radio button that enables 96-bit
Class 1 96-bit tag support. To optimize the
Support Reader keep this setting turned
off unless it is needed.
Hostname Name of the device
Server or servers to use for
NTP Server
network time protocol
Domain Name Network domain name
Primary DNS
Primary DNS server
Server
Secondary DNS
Secondary DNS server
Server
Radio button to select the default
Default
interface for network
Gateway
communications.
LAN TCP/IP Settings
Radio button that sets the Reader
Use DHCP?
to use DHCP.
Vendor Class Extra DHCP parameter for
Identifier integration and customization.
Use DHCP Set this to yes to allow the DHCP
Server supplied server to assign the Reader a
hostname hostname.
The IP address to use when not
using DHCP. It is specified in
LAN IP Address
dotted-quad notation. The default
value is 10.0.0.101.
When not using DHCP this setting
specifies the default gateway to
LAN Gateway use. It is specified in dotted-quad
notation. The default value is
10.0.0.1
TCP/IP netmask to use. The
LAN Netmask
default value is 255.255.255.0.
REV. 1.1
© OMRON CORPORATION 2004