Replacement Parts - Fluke 65 Calibration Information Manual

Model 65
Calibration Information
8. Press D to enter the high-temperature adjustment mode (display shows 2_H), as shown in Figure 2.
9. Press G. The default high-temperature appears on the UUT display.
10. Aim the UUT at the blackbody target; then use F or D to adjust the UUT reading down or up,
respectively, to read 350 °C.
11. When you have set the UUT reading to 350 °C, press G. The UUT display flashes briefly, then returns to
the calibration selection mode.
If the high temperature you enter during calibration varies greatly from the measured
temperature, the UUT display will flash Err after you press G. In this case, press G again to
exit the error mode. Verify that the blackbody is working properly; then try the calibration
again.
12. Press D to enter the end-of-calibration mode (display shows E), as shown in Figure 2. Press G to exit the
calibration menu.
13. Test the UUT's operation by running the performance tests given earlier under "Performance Tests". If
the UUT fails the performance tests, recalibrate the UUT and try the tests again. If the UUT continues to
fail, return it to a Fluke Service Center for repair or replacement.

Replacement Parts

Table 3 shows the replacement parts available from Fluke for the Model 65 Infrared Thermometer.
Top case
Bottom case
Battery door
LCD lens
End cap
Keypad
Softcase
Holster
AA battery, 1.5 V, carbon-zinc (2 required)
AA battery, 1.5 V, alkaline (2 required)
Model 65 Infrared Thermometer Instruction Sheet
Americas (English, Spanish, French, Portuguese)
European I (English, French, German, Italian, Finnish, Dutch, )
European II (English, Norwegian, Spanish, Portuguese, Swedish, Danish)
Asian (English, Korean, Japanese, Simplified Chinese, Traditional Chinese, Thai)
Model 65 Infrared Thermometer Quick Reference Card (English only)
8
Note
Table 3. Replacement Parts
Description Fluke Part Number
803566
803509
803517
803558
803525
803541
670676
670612
650181
376756
801826
801842
801859
801834
802261