Panasonic SL-VVMES2 Instruction Manual page 3

Sensor and wire-saving link system s-link

3. Mounting

Mount / Remove

Mount

VME bus rack

<Step>

1. Pull out the backplane jumper that corresponds to the slot inside the VME bus

rack.

2. Insert SL-VVMES2 in the VME bus rack.

3. After inserting SL-VVMES2 to the VME bus rack, be sure to mount it with M2.5

screws (two places).

Remove

VME bus rack

<Step>

1. Loosen the mounting screws (two places).

2. Push out the knobs to remove SL-VVMES2, and pull it out from the VME bus

rack.

3. If required, mount the backplane jumper that corresponds to the slot inside the

VME bus rack.

Notes: 1) For details of mounting and removing, refer to the instruction manual of VME bus rack.

2) When mounting SL-VVMES2, be sure to pull out the backplane jumper that corresponds to the slot

inside the VME bus rack. If the jumper is not pulled out, this product may break.

3) In case of inserting SL-VVMES2 WR WKH 90( EXV UDFN RU SXOOLQJ LW RXW WDNH VXI¿FLHQW FDUH QRW WR

come in contact with the adjacent VME bus module.

4) Before touching this product, remove any electrostatic charge that may be present on your body.

There is a danger of this product getting damaged due to the electrostatic charge.

SL-VVMES2

Push out

Insert this product by

applying equivalent

foce to both knobs.

Push out the knobs outward

to remove SL-VVMES2.

Apply equivalent force to the

knobs to remove.