Emerson Bettis RTS CL Series User Instructions page 36

Section 6: Control Unit
February 2019
Depending on the selector switch position, the control switch performs different functions:
Table 3.
Position
Selector switch
in the OFF
position:
Selector switch
in the REMOTE
position
Selector switch
in the LOCAL
position
6.3.2
Figure 37
31
Control Switch Positions
Function
The control switch is used to scroll up or down the menu according to internal
symbolism. From the neutral position towards
data areas. Towards the
selection switch either confirms
associated symbolism.
The control switch gives you access to status, history data and parameter area.
:
With the control switch, the actuator can be operated by motor. You may also
operate the actuator in inching and self-hold mode. Switches are spring-loaded
to snap back automatically into their neutral position. (To confirm a control
:
command, the control switch must be pushed all the way into its mechanical
locking position.)
Configuration
In principle, all parameters are shown as numbers in the corresponding parameter
point. From the actuator menu, use the control switch to access different menu
points. The lower left corner of the display shows the "EDIT" option.
Configuration Display (1)
you reach the status and history
symbols you reach the parameter menu. Here, the
or rejects the current input according to
User Instructions
MAN-02-04-60-0350-EN Rev. 3
Control Unit