EcoWater 3500 Series Owner's Manual page 11

ECOWATER
S Y S T E M S
SETTING RECHARGE TIME
When the softener's electronic control is first powered
up, the default time for starting regenerations is 2:00
a.m. This is a good time in most households because
water is not being used. To change this time:
1. From any of the rolling status screens, press the
SELECT ( ) button to display the Main menu.
2. Press the DOWN ( ) button to scroll through the
menu options until Basic settings is highlighted
(See Figure 28).
3. Press the SELECT ( ) button to display the Basic
settings menu (See Figure 29).
4. Press the DOWN ( ) button to scroll through the
menu options until Recharge time is highlighted.
5. Press the SELECT ( ) button to display the
Recharge time screen (See Figure 30).
6. Press the UP ( ) or DOWN ( ) buttons to change
the recharge time. Hold the button down to rapidly
advance. Be sure that AM or PM is correct
7. Press the SELECT ( ) button. The display will go
back to the Basic settings menu.
8. Press the LEFT ( ) button twice to return to the
rolling status screens.
SETTING HARDNESS
When the softener's electronic control is first powered
up, a "wizard" screen prompts you to enter your
water's hardness (See Page 6). To change it:
1-3. Go to the Basic settings menu by following Steps
1-3 in the "Setting Recharge Time" procedure at
left.
4. Press the DOWN ( ) button to scroll through the
menu options until Hardness is highlighted.
5. Press the SELECT ( ) button to display the
Hardness screen (See Figure 31).
FIG. 28
6. Press the UP ( ) or DOWN ( ) buttons to set the
value for your water's hardness. Hold the button
down to rapidly advance.
7. Press the SELECT ( ) button. The display will go
back to the Basic settings menu.
8. Press the LEFT ( ) button twice to return to the
rolling status screens.
FIG. 29
SETTING IRON LEVEL
When the softener's electronic control is first powered
up, a "wizard" screen prompts you to enter your
water's iron level (See Page 6). To change it:
1-3. Go to the Basic settings menu by following Steps
1-3 in the "Setting Recharge Time" procedure at
left.
4. Press the DOWN ( ) button to scroll through the
menu options until Iron level is highlighted.
FIG. 30
5. Press the SELECT ( ) button to display the Iron
level screen (See Figure 32).
6. Press the UP ( ) or DOWN ( ) buttons to set the
value for iron in your water. Hold the button down
to rapidly advance.
7. Press the SELECT ( ) button. The display will go
back to the Basic settings menu.
8. Press the LEFT ( ) button twice to return to the
rolling status screens.
11
Softener Operation
FIG. 31
FIG. 32