Starting The Test; Stopping The Test - Check If Test Complete; Disassembling And Returning The Device - ResMed ApneaLink Air Patient Instructions

Starting the test

Test complete
When properly set up, the full
system looks like this.
Once you have started the test, go to sleep as normal. The lights on the device will dim after 10 minutes. If you have to get up during the
night for any reason, leave the device on unless you do not intend to go back to sleep. You can remove the oximeter finger sensor if you
need to go to the bathroom or wash your hands. Replace the oximeter finger sensor before going back to sleep.

Stopping the test - check if test complete

1
Test complete
1. Press the power button for
about three seconds.
Note:
• To re-check the test complete indicator light, press the power button until the light turns on (about three seconds), then briefly press
the power button again.
• To replace the batteries, open the battery cover on the back of the device and insert two new AAA batteries.
• The device does not need any servicing or maintenance before recording.

Disassembling and returning the device

When the test is completed:
1. Remove the belt from your body.
2. Remove all the connectors from the device.
3. Screw the protective caps back on the effort sensor and nasal cannula connectors.
4. Disconnect the finger sensor from the oximeter.
5. Remove the device from the belt.
6. Throw away the nasal cannula and the disposable finger sensor (see the Equipment section on the first page).
7. Place everything else back in the bag and return it to your physician or healthcare provider as requested.
Do not attempt to clean the device.
1
Test complete
1. Press and hold the power
button in the centre of
the device for about three
seconds or until the light
turns on.
2
Test complete
2. Check that the test
complete indicator light is lit
and green. This means the
test is complete. If the test
indicator light is red, replace
the batteries and repeat the
test tomorrow night.
2
Test complete
2. Check that lights next to the
accessories you are using
are green. If any of these
lights are red and blinking,
the accessories are not
attached correctly.
3
Test complete
3. Press and hold the power
button for about three
seconds to turn off the
device.
7