Usb Ports; Rj45 Lan Ports - DFI PIC-Q170 User Manual

USB Ports

USB 1
USB 5-6
VCC
-Data
+Data
GND
USB 2 USB 1-2 USB 3-4
(Q170 Only)
USB 3.0
USB allows data exchange between your computer and a wide range of simultaneously acces-
sible external Plug and Play peripherals.
The PIC-Q170 is equipped with two onboard USB 3.0 ports (USB 1&2). The three 10-pin con-
nectors allow you to connect 6 additional USB 2.0 ports (USB 1-2/3-4/5-6). The one 20-pin
connector allows you to connect 2 additional USB 3.0 ports (USB 3-4).
The PIC-H110 is equipped with two onboard USB 3.0 ports (USB 1&2). The two 10-pin con-
nectors allow you to connect 4 additional USB 2.0 ports (USB 3-4/5-6).
The additional USB ports may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis and then insert the USB port
cables to a connector.
BIOS Setting
Configure the onboard USB in the Advanced menu ("USB Configuration" submenu) of the
BIOS. Refer to chapter 3 for more information.
Chapter 2 Hardware Installation
USB 3-4
(Q170 Only)
1 2
VCC
-Data
+Data
GND
N.C.
9 10
USB 2.0
USB 3.0
Chapter 2

RJ45 LAN Ports

LAN 1 LAN 1 LAN 2 LAN 2
Features
• 1 Intel I211AT Gigabit Ethernet LAN controller
®
• 1 Intel I219LM Gigabit Ethernet LAN controller
®
The LAN ports allow the system board to connect to a local area network by means of a net-
work hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu ("South Bridge Configuration" submenu) of
the BIOS. Refer to chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
16
www.dfi .com