Periodically the robot should receive a thorough inspection.
1.
Examine the exterior of the robot and make repairs as necessary. See the robot
body repair instructions if needed.
2.
Remove the body. Check all bolts and nuts for tightness.
3.
Examine electrical wiring and connectors for looseness and wear.
4.
Clean and lubricate mechanical parts of the robot such as the front wheel
casters as needed. Inspect the drive belt and pulley system making sure that
the motor pulley set screws are tight. You can use belt dressing on the drive
belts if they are dry or squeaky.
5.
Clean the cassette tape system according to instructions in the Cassette Tape
Player pages.
6.
Wash the robot body with mild soap and water and a soft cloth and reattach the
body. (Rubbing alcohol may be used on stains that won't come off with soap. If
this causes the finish of the plastic to become dull, apply ARMOR-ALL brand
protectant. Do NOT use alcohol on the eyes.
7.
Check the Radio Control System and Voice Transceiver for broken wires,
controls, cases, etc. The metal clips that are in the voice units and contact the 9
Volt battery, should be bent out routinely to maintain good contact.
8.
Fully charge the battery and test all robot system functions. This must be done
on a daily basis when the robot is in constant use. Remember, the robot battery
should be brought to a full charge after each use of the robot so that it always
has a full charge on it.
To prolong the life of your robot system, always store in a safe place away from light, dust,
moisture, and excessive heat.
robot cover should be used.
should be stored fully charged. Transport and store the robot standing up. (Never upside
down!)
For a list of recommended tools for a tool kit, see the next page. Ask us about the Robot
Maintenance tool kit that is available.
PART 4
CHAPTER 11 Maintenance
Regular Maintenance Checklist
To keep dust and light away from the robot, a
The robot and Radio Control Transmitter batteries
35
Need help?
Do you have a question about the Pluggie Robot and is the answer not in the manual?
Questions and answers