Radio Control Transmitter Controls - Robotronics Pluggie Robot Operating Manual

10
Note:
The following information on the transmitter controls includes information for a variety of
similar robots.
Important RC power up steps:
1. Put the top switches in the position away from you.
2. Turn on the power switch. The display will read switch error.
3. Pull the very top left switch and the display will now come on.
1. Telescopic Transmitter Aerial.
2. LCD Display and Transmitter Battery Voltage Meter (Expand Scale Voltmeter). Battery
Voltage is typically over 10 Volts with a fully charged battery. 8.5 Volts or less is low
and the battery should be changed. There will be an audible beep when the battery is
low.
3. Right control Stick-
Up and Down – Robot drive motors, forward and reverse.
Right and Left – Robot drive motors steering. Left and right turns.
4. Forward/Reverse Trim lever for right control stick. Normal = Center. Neutrals the drive
motors. If the robot is moving slightly slide this a few clicks until robot stops moving.
5. Left and right Trim lever for right control stick. Normal = Center. Neutrals the drive
motors. If the robot is moving slightly slide this a few clicks until robot stops moving.
6. RC Frequency range. This is a 2.4 GHz system.
7. On/Off Switch.
8. Recharge jack. Plug the RC battery charger in here to recharge the internal battery.
The charge light will come on, on the charger.
9. Forward and reverse trim lever for the left control stick. Normal = Center. Unused.
10. Left and right Trim lever for left control stick. Normal = Center. Centers the head on
robots with head movement (Character in Vehicle).
RC Transmitter Controls
CAUTION
Do not change menu settings on this RC or you
may lose functionality and the settings would
need to be restored.