Xirrus Wi-Fi Array XN16 User Manual page 211

Wi-Fi Array
processor as well as out Gigabit1. This allows a network analyzer to
be plugged into one port to capture traffic for troubleshooting, while
the other port provides network connectivity for data traffic. See
Figure 109
6. Configuration Server Protocol: Choose DHCP to instruct the Array to
use DHCP when assigning IP addresses to the Array, or choose Static IP
if you intend to enter IP addresses manually. If you select the Static IP
option you must specify the IP address, IP subnet mask and default
gateway.
a. IP Address: If you selected the Static IP option, enter a valid IP
address for the Array. To use any of the remote connections (Web,
SNMP, or SSH), a valid IP address must be established.
b. IP Subnet Mask: If you selected the Static IP option, enter a valid IP
address for the
The subnet mask defines the number of IP addresses that are
available on the routed subnet where the Array is located.
Default Gateway: If you selected the Static IP option, enter a valid IP
c.
address for the
that the Array uses to transmit data to other networks.
7. Static Route (IP Address/Mask): (Fast Ethernet port only) The 10e100
Ethernet Port may be used for managing the Array out of band from the
Gigabit Ethernet ports. The 10e100 port will route only management
traffic, using a static route that may be configured using this field.
8. When done configuring all interfaces as desired, click on the Apply
button to apply the new settings to this session, or click Save to apply
your changes and make them permanent.
See Also
DNS Settings
Network
Network Statistics
Spanning Tree Status
Configuring the Wi-Fi Array
(f).
subnet mask (the default for Class C is 255.255.255.0).
default gateway. This is the IP address of the router
189