Wps; Cannot Connect. Multiple Access Points Are Enabled. Is Displayed; Connection Failed. Is Displayed; Problems During Software Installation - Canon MG8150 Troubleshooting Manual

WPS

Cannot connect. Multiple access points are enabled. is Displayed

Action
The message appears when multiple access points are
detected.
Wait for a while, then configure the settings again.

Connection failed. is Displayed

Check
The message appears when an error occurs.
Check the access point settings, then configure WPS
settings again.
• For details on how to check the settings of the access point,
refer to the manual supplied with the access point or contact its
manufacturer.
• For the procedure to configure WPS settings of the machine,
refer to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" in
the printed manual: Getting Started.
• When using an access point that does not support WPS, configure settings manually. For the
procedure to configure settings of the machine manually, refer to "Wireless Setup Using Easy
Setup" in the printed manual: Getting Started.

Problems during Software Installation

The Machine is Not Displayed (Detected)

Check
A
Check 1
For a wireless connection, make sure that you follow Check 1, 2, 3, 4, 5 and 8 of
"Connection Checklist" on page 15, then click Update (A).
For a wired connection, make sure that you follow Check 1, 2, 6, 7 and 8 of
"Connection Checklist" on page 15, then click Update (A).
Check 2
Is the machine connected to a network?
• To confirm the connection status, use the { or } button to display Setup on the HOME screen
and touch the right FUNCTION button, then using the { } [ ] and OK buttons, select
Device settings > LAN settings > Confirm LAN settings > WLAN setting list or LAN setting
list. Make sure that Connection is set to Active.
If the machine is not connected to a network, perform setup again by following the
procedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printed
manual: Getting Started.
A