What To Do If - Smeg CE6IMX Instructions For Installation And Use Manual

14.4 what to do if...

The oven display is completely off:
The oven does not heat up:
The controls do not respond:
The cooking times are longer than those
indicated in the table.
After the automatic "pyrolysis" cleaning cycle
(only on some models) it is not possible to
select a function:
The display shows ERR 4
(on pyrolytic models only):
If the door is opened during a fan-assisted
function, the fan stops:
If the problem has not been resolved or there are other types of faults, contact your local technical
assistance centre.
54
Instructions for the User
• Check the mains power supply.
• Check whether an omnipolar switch upstream
from the oven feed line is in the "ON" position.
• Check whether the "showroom" mode has been
set, for further details see point "10.7 Secondary
menu".
• Check whether the "child lock-out function"
mode has been set, for further details see point
"10.7 Secondary menu".
• Check whether the "power limiter" mode has
been set, for further details see point "10.7
Secondary menu".
• Verify whether the interlock device has been
switched off. If it has not, the oven has a
protection device that does not allow functions
to be selected while the interlock device is
active.
• The interlock device has not hooked up to the
door properly. This might be because the door
was accidentally opened during its activation.
Switch off the oven and switch it on again
waiting a few minutes before selecting a new
cleaning cycle.
• This is not a fault. It is a normal operation of the
appliance, useful when cooking foods in order to
avoid excessive heat escaping. When the door
is closed, the oven will return to normal
operation.