Husqvarna P 520D Operator's Manual page 30

To replace the warning lights
1. Disconnect the cables from the broken lamp.
2. Remove the screw on the connector.
3. Remove the lamp connector with the lamp attached.
4. Attach the new lamp connector. Refer to
data on page 44 .
5. Connect the cables to the new lamp.
To do a check of the parking brake
1. Park the product on a hard surface that slopes.
Note: Do not park the product on a grass slope
when you do a check of the parking brake.
2. Push the parking brake forward.
3. If the product starts to move, let an approved service
agent adjust the parking brake.
4. Pull the parking brake rearward to release the
parking brake.
To do a check of the parallelism of
the cutting deck
1. Do a check of the air pressure in the tires. Refer to
Tire pressure on page 33 .
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
30
a) Combi 132 and Combi 155 must be measured in
b) Combi 132 X and Combi 155 X must be
Technical
To adjust the parallelism of the
cutting deck
1. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the cover.
Make the track rod shorter to lower the rear edge of
the cover.
2. Tighten the nuts on the track rod.
3. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
30 .
2 areas. Make sure that the rear edge is 6–9 mm
(1/4 - 3/8 in.) higher than the front edge.
measured in 4 areas. Make sure that the rear
edge is 6–9 mm (1/4 - 3/8 in.) higher than the
front edge.
To do a
740 - 004 -