Husqvarna P 520D Operator's Manual page 14

11. Pull back the coupling of the drive shaft and attach
the drive shaft to the shaft journal.
12. Fold the rubber casing above the shaft joint.
13. Put the lock chain around the cross pipe.
14. Attach the lock chain to the drive shaft.
15. Attach the bottom plate and tighten the screws.
16. Start the engine.
17. Set the lift lever for the cutting deck in the transport
position.
18. Stop the engine.
19. Pull the spring (A) and attach to the lift eyes on the
cutting deck (B).
B
20. Do a check of the parallelism of the cutting deck.
To do a check of the parallelism of the
Refer to
cutting deck on page 30 .
To attach the cutting deck Combi
132 X, Combi 155 X
To attach the cutting deck Combi
1. Do step 1-20 in
132, Combi 155 on page 13 .
14
A
2. Put the hydraulic hoses from the cutting deck
through the loop.
3. Attach the hydraulic hoses to the coupling on the
product.
Note: The position of the hydraulic hoses controls
the operation function of the cutting height lever. To
change the operation function of the cutting height
lever, change the position of the hydraulic hoses.
To remove the cutting deck
1. Park the product on level ground.
2. For Combi 132 X and Combi 155 X, release the
couplings and disconnect the hydraulic hoses.
3. Apply the parking brake.
4. Set the cutting height lever in the service position.
5. Stop the engine.
740 - 004 -